Call (208) 546-5906

Home / Services

Pilot Light Repair Nampa ID: Thermocouples, Pilots, and Gas Safety

Your pilot light will not stay lit, or it went out and will not relight. No hot water, and a gas heater that will not fire. In most cases the cause is one small part: the thermocouple. This page tells you what the pilot and thermocouple do, why the pilot goes out, what the repair costs, and when a gas smell means leave the house first.

Technician inspecting a pilot light on a gas water heater in Nampa

Your pilot light will not stay lit, or it went out and will not relight. No hot water, and a gas heater that will not fire. In most cases the cause is one small part: the thermocouple. This page tells you what the pilot and thermocouple do, why the pilot goes out, what the repair costs, and when a gas smell means leave the house first.

Nampa HeatPros repairs pilot lights and thermocouples in Nampa, Idaho. We test the thermocouple, the pilot assembly, and the gas supply before we replace anything, so you pay for the part that failed. Most pilot repairs finish in one visit.

What the Pilot Light and Thermocouple Do

A gas water heater has a small flame, the pilot light, that burns all the time. Its job is to light the main burner when the thermostat calls for heat. The pilot burns gas from a small line, and it stays lit day and night.

The thermocouple is a small metal probe that sits in the pilot flame. When the flame heats it, the thermocouple makes a tiny electric current. That current holds the gas valve open. It is a safety device. If the pilot goes out, the thermocouple cools, the current stops, and the gas valve closes. No gas flows to a burner with no flame.

That is why a pilot that will not stay lit is usually a thermocouple problem. The pilot lights, the flame heats the thermocouple, but the thermocouple does not make enough current to hold the valve open. The valve closes, the flame dies, and the water stays cold.

The pilot assembly also has an orifice, a tiny hole that feeds gas to the pilot flame. If the orifice clogs with dust or soot, the flame gets weak and small. A weak flame cannot heat the thermocouple, and the pilot goes out.

Why Your Pilot Light Will Not Stay Lit

Failed thermocouple. The most common cause. The thermocouple wears out, and it no longer makes enough current to hold the gas valve open. The pilot lights, burns for a few seconds, then goes out. The fix is a new thermocouple.
Dirty pilot orifice. Dust, soot, or spider webs clog the tiny gas hole. The pilot flame gets weak and small. It cannot heat the thermocouple. The fix is to clean the orifice.
Faulty gas valve. The gas control valve itself has failed. It will not stay open even with a good thermocouple. A gas valve costs more than a thermocouple, and it is the repair where a second quote pays for itself.
Draft or venting issue. A draft from a vent, a window, or a door can blow the pilot out. A blocked vent can starve the burner of air. We check the venting and the draft before we replace parts.
Gas supply issue. The gas is off, the gas line is closed, or the pressure is too low. Check that the gas valve to the heater is open. If the gas is on and the pilot still will not light, call a plumber.
Old heater. A heater past 10 years old with a failed thermocouple and a history of breakdowns may not be worth another repair. A tank heater lasts 8 to 12 years, according to the U.S. Department of Energy. The 50 percent rule on our cost page covers the decision.

Pilot Light and Thermocouple Repair Cost in Nampa

Here are the national figures, labelled as national, with sources and dates.

Pilot light repair: $75 to $175. Fixr, updated August 29, 2025, puts a pilot light repair at $75 to $175. Relighting a pilot is often a service call only. If the pilot assembly itself has failed, the cost rises into thermocouple range.
Thermocouple replacement: $100 to $325. Fixr puts a thermocouple at $150 to $325. HomeGuide puts it at $100 to $325. It is a small part and a quick fix, often under an hour.
Gas control valve replacement: $150 to $550. HomeGuide puts a gas control valve at $150 to $550. It is the most expensive common gas repair. If a plumber tells you the gas valve has failed, get a second quote before you approve it.
What the bill looks like. A typical bill has three parts. The trip fee, usually $50 to $200. Labor, usually $75 to $150 an hour, with most pilot and thermocouple jobs taking about an hour. And the part itself. We split all three out in our quote.
Thermocouple versus new tank. A standard tank replacement averages about $1,400 installed, according to Fixr. A $100 to $325 thermocouple on a tank that does not leak is the right spend. A thermocouple cannot save a tank that has rusted through. If the tank leaks, replacement is the only option.

These are national figures, not Nampa prices. Nampa prices vary by unit, access, and how much scale is in the tank. We give you a written quote for your home before any work starts.

Gas Smell Safety: What to Do First

If you smell gas, do not try to relight the pilot. Do not flip a light switch. Do not use the phone inside the house. Leave the house first.

Gas smells like rotten eggs. The gas company adds that smell so a leak is easy to notice. If you smell it near the water heater, or anywhere in the house, leave right away. Go outside. Call the gas utility or 911 from outside the house, or from a neighbour's phone.

Do not turn lights on or off. Do not start the car in the garage. Do not light a match. A spark can ignite gas in the air. Wait outside until the gas company says it is safe to go back in.

A pilot that will not stay lit is not a gas leak. But a strong gas smell with no pilot flame can mean gas is flowing without a flame to burn it. That is why the rule is simple: smell gas, leave first, call second, relight never.

We check for gas leaks on every pilot visit. If we find one, we shut the gas off and tell you to call the gas company. Your safety comes before the repair.

How We Fix a Pilot That Will Not Stay Lit

  1. We check for gas leaks. We smell for gas and check the connections. If we find a leak, we shut the gas off and tell you to call the gas company. No repair starts until the house is safe.
  2. We test the thermocouple. We light the pilot and watch it. If the pilot lights and dies in seconds, the thermocouple is the likely cause. We test it with a meter to confirm.
  3. We clean the pilot orifice. If the flame is weak and small, the orifice is clogged. We clean it and relight the pilot. A clean orifice gives a strong blue flame that heats the thermocouple.
  4. You get an upfront price. We tell you the price before any work starts, with parts and labor split out. You approve it, then we fix it. The price does not change halfway through.
  5. We replace the part and test. We fit the new thermocouple, relight the pilot, and watch it hold. We test the water temperature at the tap and check the venting. We show you how to relight the pilot yourself, and when to call us instead.

Nampa Winters and Pilot Problems

Nampa sees about 132 nights a year at or below freezing, based on NOAA 1991 to 2020 climate normals. January averages a low of 23 degrees. Winter is when pilot problems show up most.

Cold air makes drafts stronger. A draft from a garage door, a vent, or a window can blow a weak pilot out. A pilot that held all summer can fail on the first cold night. The cause is usually a worn thermocouple that was already weak, and the draft finished it.

Winter also brings more demand. A heater that runs all day to keep up with cold inlet water works harder, and a weak part fails faster. If your pilot has gone out twice in one winter, the thermocouple is probably worn. Replace it before the next cold snap.

A heater in a garage or crawl space needs insulation on the pipes and a clear vent. We check both on a pilot visit, so the repair lasts through the winter.

Why Nampa Homeowners Call Nampa HeatPros for Pilot Light Repair

Water heater specialistsOur plumbers work on water heaters all day, every day. They know the models on Nampa shelves, the parts that fail first, and the error codes on the display. A plumber who sees ten water heaters a day does not guess at the fault.
We test before we replaceA pilot that will not stay lit can be the thermocouple, the orifice, the gas valve, or a draft. We test each one, so you pay for the part that failed.
Gas safety firstWe check for gas leaks on every pilot visit. If we find one, we shut the gas off and tell you to call the gas company. Your safety comes before the repair.
Local to Nampa and Canyon CountyWe work in Nampa, not across the whole state. We know the water, the winters, and the housing here.
Upfront pricingYou approve the price before work starts. No surprise charges, no upsell.
Our guaranteeOur repairs carry a workmanship guarantee, and parts carry the maker warranty. Ask us what the guarantee covers before we start.

Pilot Light Repair Across Nampa

We drive to homes all over Nampa, and to Meridian, Caldwell, Kuna, Middleton, Star, and Boise. In Nampa, that means downtown and the historic streets near the Nampa Depot, North Nampa, South Nampa around Lake Lowell, East Nampa along Ustick Road, the NNU area, West Nampa near Garrity Boulevard, and the Karcher and Greenhurst area.

Older homes near downtown, around Nampa High School and the streets off 1st Street South, often have gas tanks past 10 years old with original thermocouples. Newer homes in Copper River Basin, Karcher Estates, Sundance, and the Ten Mile corridor have newer units, but Nampa hard water and winter drafts wear their pilots just as fast. Homes near Lake Lowell and Heron Ridge sit close to the Deer Flat National Wildlife Refuge, where winter nights run cold and garage heaters work hard.

If you live near the Ford Idaho Center, the Warhawk Air Museum, Lakeview Park, or Northwest Nazarene University, you are in our service area.

Pilot Light Repair in Nampa: FAQs

Why does my pilot light keep going out?

The thermocouple is the most common cause. It wears out and no longer makes enough current to hold the gas valve open. A dirty pilot orifice, a faulty gas valve, or a draft can cause it too. We test each one to find the failed part.

How much does it cost to replace a thermocouple?

Nationally, a thermocouple replacement runs $100 to $325, parts and labor, according to Fixr and HomeGuide. A pilot light repair runs $75 to $175. These are national figures. We give you a written quote before any work starts.

Can I relight the pilot light myself?

Yes, if there is no gas smell. Follow the lighting instructions on the side of the tank. If the pilot lights and dies in seconds, the thermocouple has failed. If you smell gas, do not relight it. Leave the house and call the gas utility or 911 from outside.

What should I do if I smell gas?

Leave the house right away. Do not flip light switches or use the phone inside. Call the gas utility or 911 from outside the house, or from a neighbour's phone. Wait outside until the gas company says it is safe to go back in.

Is a pilot light problem an emergency?

No hot water in winter is urgent, and a gas smell is an emergency. A pilot that will not stay lit with no gas smell can wait until morning, but it will not fix itself. Call us and we will book the next available visit.

Book Your Pilot Light Repair in Nampa Today

A pilot that will not stay lit is usually a $100 to $325 thermocouple, not a new heater. Call Nampa HeatPros. We will test the thermocouple, tell you the price in writing, and fix it the same day in most cases. And if you smell gas, leave the house first and call the gas utility from outside. That is how pilot light repair Nampa ID should work.


Our Service Area

We serve Nampa and the towns around it. Pick your area to see water heater repair there.

Water Heater Repair in Caldwell, IDWater heater service in Caldwell, IDWater Heater Repair in Star, IDWater heater service in Star, IDWater Heater Repair in Middleton, IDWater heater service in Middleton, IDWater Heater Repair in Meridian, IDWater heater service in Meridian, IDWater Heater Repair in Kuna, IDWater heater service in Kuna, IDWater Heater Repair in Huston, IDWater heater service in Huston, IDWater Heater Repair in Greenleaf, IDWater heater service in Greenleaf, IDWater Heater Repair in Melba, IDWater heater service in Melba, IDWater Heater Repair in Notus, IDWater heater service in Notus, IDWater Heater Repair in Downtown Nampa, IDWater heater service in Downtown Nampa, IDWater Heater Repair in North Nampa, IDWater heater service in North Nampa, IDWater Heater Repair in South Nampa, ID (Midland / Lake Lowell)Water heater service in South Nampa, ID (Midland / Lake Lowell)Water Heater Repair in East Nampa, ID (Ustick / Ten Mile)Water heater service in East Nampa, ID (Ustick / Ten Mile)Water Heater Repair in West Nampa (Garrity / Ford Idaho Center), IDWater heater service in West Nampa (Garrity / Ford Idaho Center), IDWater Heater Repair near Northwest Nazarene University, Nampa, IDWater heater service near Northwest Nazarene University, Nampa, IDWater Heater Repair in the Karcher / Greenhurst Area, Nampa, IDWater heater service in the Karcher / Greenhurst Area, Nampa, IDWater Heater Repair in Lake Lowell / Deer Flat, Nampa, IDWater heater service in Lake Lowell / Deer Flat, Nampa, ID

No hot water in Nampa?

Same-day emergency water heater repair, upfront pricing, local specialists.

Call Now (208) 546-5906
(208) 546-5906